Mounting Tabs & Adhesives

The genuine replacement for DAG 915, used widely in electron microscopy and electronic circuitry for capacitor terminations, electrostatic screening, coating of UHF reflectors and electroplating on non-conductors.

Highly electrically conductive carbon adhesive tabs with a thin aluminium foil (30µm) core suitable for SEM or EDX applications.

Carbon based, electrically conductive, double sided adhesive discs, also known as Leit tabs.

Spectrotabs have a much lower level of impurities than standard carbon (Leit) tabs, avoiding anomalous results during X-ray analysis of small particles and powders.

Available in 6mm & 9mm diameter

Conductive carbon adhesive tabs with a thin film of strong adhesive, approximately 12.5mm diameter.

Sticky tabs may be affixed to 12.5mm specimen stubs, leaving a layer of adhesive when the backing is removed.

A highly electrically conductive carbon adhesive tape with a thin aluminium foil (30µm) core suitable for SEM or EDX applications.

Electrically conductive, non-porous carbon tapes suitable for SEM or EDX applications.

Double-sided Kapton® tape consists of a thin Kapton film with a silicone adhesive on both sides of the Kapton polyimide film.

A preparation of fine, pure colloidal graphite in water. 500g. 

A highly conductive silver paint with an acrylic binder.

Loctite® 460 is a fast curing, low odour, low viscosity glue which can be used as an alternative to wax for mounting samples on glass for TEM/FIB thinning. 50g. 

DAG 580 is a graphite lubricant which forms a thin, dry film.

Fast drying, alcohol based silver paint.

Finely distributed silver in a less volatile carrier fluid, therefore the suspension dries out slower than most silver paints.

A suspension of finely divided gold particles, useful for analytical work where silver is not suitable.

Conductive graphite paint with isopropanol base.

Silver pen suitable for affixing samples to SEM stubs, making instant conductive traces.

Leit C ia a conductive plasticine like material that can be used to mount larger specimens on SEM stubs.

Leit C is a suspension of very fine conducting carbon particles in a volatile carrier, suitable for forming conducting bonds between specimens and stubs.

M-Bond 610 is a non-conductive, two-component, solvent-thinned epoxy-phenolic adhesive for high performance applications.

A very fine flake silver is suspended in methyl isobutylketone (4-methylpentan-2-one) and forms a thin, smooth, highly conductive silver film which is both adherent and flexible.

Crystalbond adhesives allow temporary bonding of delicate crystals, metallurgical samples, glass components and ceramic substrates.